overview

Isotherm CR90 BIG Cruise Classic Two Door Marine Fridge/Freezer (1090BB1AA)

12 to 24 Volt DC - 70L Fridge and 20L Freezer

Two Door Marine Fridge with Freezer

Right Hand Door Hinge

Suitable for Boats - Caravans - Motorhomes and RV's

We ship Australia wide - Ask us for a quote!

The CR 90 BIG is a two door fridge-freezer solution. The refrigerator provides a volume of 70 liters and the freezer a volume of 20 liters. The refrigerator is equipped with interior light in the fridge compartment.

Features:

• Food preparation compliant case
• Flush mounted - no protrusion into galley area
• Positive, flush closing mechanism
• Hermetic fan cooled compressor
• Contoured single piece plastic liner
• Adjustable shelves
• Internal light
• Low voltage cut off
• Radio interference suppression
• Internal rotary thermostat
• Utilises R134A ozone friendly refrigeration gas

Isotherm Cruise 90L Classic Grey Line Product Info:

• Volume: 90 liters (fridge: 70 liters, freezer: 20 liters)
• Silent, high efficient, fan cooled 12/24V Danfoss / Secop compressor (type BD35F)
• Interior light
• Two door fridge-freezer solution

Options:

• SGB00082AA – 3-SIDE FIXING FRAME CR90FR/CR130 Painted BLACK

Downloads:

• Isotherm Cruise Marine Refrigerator Brochure
• Isotherm Cruise & Elegance Manual
• Isotherm Cruise 90L Big Spare Parts List

specification

Ventilation:

It is very important that the compressor/condenser unit is well ventilated and that cold air can enter at the bottom, pass behind the fridge and warm air can leave at the top in the area where it is mounted. The natural flow of air from below and upwards behind the fridge can be increased by arranging  ventilation openings at the rear. Make sure there is a free area of 15 - 23 sq.in. below and behind the refrigerator to allow ventilation air to pass behind from below. (see diagram below).

Electrical Connections:

When connecting the refrigerator electrically, it is important that following points are considered:
Always use cables of suffi cient area. The area in the following table should be regarded as a minimum. * Always connect the refrigerator directly to the battery or to the battery main switch on the plus circuit. Do not connect it via the boats own control panel or other diversions as this can cause a voltage drop in the power supply. Use the included fuse holder with a 15A fuse. Use 7.5A fuse in a 24 volt system. The fuse shall be mounted on the plus cable.
*Connect the red cable to the positive (+) terminal and the black to the negative (-) terminal. Use tab type terminals for the connection to the electronic unit and other cable connectors of sufficient size for the cable size selected. * Do not connect the refrigerator direct to a battery charger. The battery charger must be connected to the battery.

Battery Voltage (Shut Down) Sensor:

To protect the batteries from becoming completely discharged, a battery voltage sensor switches off the compressor automatically at the following levels:

Wire Dimensions:

The correct wire gauge  and type must be used.